Milling instead of drilling

Replacing a drill by a milling cutter to drill bores into a workpiece is a suggestion that takes some getting used to and initially causes many manufacturers to frown. However, the technology change makes sense for some parts, especially in the field of e-mobility. MAPAL shows that this not only allows greater process reliability, but even shorter machining times.

[Read the full article below]

https://mapal.com/en-int/a/fraesen-statt-bohren

Other news

Four inserts for stator bores

MAPAL has developed a complex four-bladed actuating tool to round off its solution portfolio for stator drilling...

Even more cost-effective turbochargers

MAPAL has expanded its portfolio for turbocharger housing in order to make the entire machining process even more productive.

Basic, Performance, Expert - Tool solutions for e-mobility

The new Basic, Performance and Expert classification describes customer-specific solutions for their machining.

The best deep bores with PCD

When the Schlote Group built a new factory in Harzgerode in 2017, it was designed to mass produce only a single part. MAPAL supplied all the cutting tools. By optimising the tools, the foundation has now been laid for a future with new products.

CFRP machining optimised with OptiMill-Composite-Speed-Plus

Improved clamping technology for large carbon-fibre parts enables the aerospace industry to machine more quickly. MAPAL supports this development with new tools.